, ABT-263 purchase 2005; Militello et al., 2008). Briefly, isolated E. coli DNA (1 μg) from overnight cultures was digested to nucleosides using sequential treatment with S1 nuclease, snake venom phosphodiesterase, and alkaline phosphatase before separation on a dC18 column. Tandem mass spectrometry was used to detect the molecular ion (242.1 atomic mass units) and product ion (126.3 atomic mass units) for 5mdC. Simultaneously, the molecular

ion and product ion for 2′-deoxyguanosine were detected. The ratios of 5mdC to 2′-deoxyguanosine in the experimental samples were compared to a standard curve of the same two nucleosides, to generate percent 5mdC. At least three distinct biological samples Caspase pathway (separate cultures) were used for each strain, except for the commercial E. coli B preparation (four technical replicates). Overnight E. coli cultures were diluted 1 : 100 into fresh LB medium and grown at 37 °C

until early logarithmic phase (OD600 nm of ~0.4) and early stationary phase (OD600 nm of ~3.0). Total RNA was isolated using the MasterPure RNA Isolation kit (Epicentre). cDNA was made from 2 to 3 μg of RNA in presence of random primers. qPCR was performed on a Stratagene Mx3000P machine with Stratagene Brilliant Sybr Green qPCR master mix. Primer sequences are found in Fig. S1. Reactions were performed in triplicate and at least two different RNA samples were tested (biological replicates). A PCR assay was developed to detect the presence of the dcm gene in E. coli. Forty-one E. coli and Shigella full-length dcm DNA sequences were obtained from NCBI (http://www.ncbi.nlm.nih.gov/genomes/lproks.cgi). Decitabine ic50 The sequences were aligned using ClustalX 2.0.10 (www.clustal.org/) and used to construct a N-J tree (Fig. S2). To develop a set of PCR primers for the full-length gene (1419 basepairs), the sequences at the beginning and the end of the alignment were examined. The first 88 nucleotides of all gene sequences were identical, and one forward primer was chosen. While there are three possible reverse primers, reverse primer III is present

in only one sequence, and we therefore used a mixture of reverse primers I and II for all experiments. Initial PCRs were optimized using E. coli JM109 DNA (dcm+) as a positive control, and the reactions routinely generated a product of the expected size of 1419 basepairs (Fig. 1a). The assay was specific, as the dcm PCR product was not observed in reactions without DNA template or with DNA from E. coli GM204, a strain with a deletion of the dcm operon. To confirm that the PCR product truly represented the dcm gene, the PCR DNA from E. coli JM109 was purified and analyzed by DNA sequencing (data not shown). Subsequently, we used the PCR assay to screen the E. coli strains from multiple sources.