The 3-D governing equation for the computation of temperature distribution for the cylinder model is?2T=0(1)In the computation, the heat flux at selleck chemical heat source is set as 8.91��105 W/m2K, and the temperature at selleck chem the bottom of the cylinder is maintained at 25 ��C. All other boundaries are assumed to be adiabatic, Inhibitors,Modulators,Libraries because the heat conduction through the aluminum is much faster than the convection to the air. For the 3-D numerical solution Inhibitors,Modulators,Libraries of Eq. (1), the grid structure was made as illustrated in Figure 3. Because high temperature gradient is expected near the heat source and groove, relatively large numbers of nodes are assigned there. Total number Inhibitors,Modulators,Libraries of nodes is approximately 1,000,000. Grids are also constructed along the radial direction.
Four-node grids are used around the Inhibitors,Modulators,Libraries heater, and 20-node grids around the groove.
Inhibitors,Modulators,Libraries The commercial software CFX (ANSYS Inc., U.S.A., Ver. 11.0) was utilized in the numerical simulation.Figure 3.Grid structures for three-dimensional numerical simulation: (a) around the heat source, (b) around the groove.3.?Experimental3.1. Preparation of sensor moduleIn order to measure temperature distribution of the aluminum cylinder, five infrared thermometers (Heimann Sensor Inhibitors,Modulators,Libraries GmbH, Germany, Model 3129)��built in a specially designed module as described in Figure 4��were utilized in this experiment. Though the sensor has a circular optical window of 3 mm in diameter, it has 9 mm tin casing as illustrated in Figure 4a.Figure 4.
A schematic diagram of sensor holder and dimensions of sensor(a), left-line hole(b) and right-line hole(c).
When the sensors are placed in a line, there is undetected area between two adjacent sensors due to the large casing with small optical window. For the reduction Inhibitors,Modulators,Libraries of the undetected Inhibitors,Modulators,Libraries area, a specially designed module made of bakelite was implemented as demonstrated in Figure 4. The five sensors in the module are placed in two lines. Three sensors are located in the left line Cilengitide with short length of viewing holes, while two sensors are in the right with long holes. Locating them in a staggered arrangement minimizes the undetected area when the module horizontally scans the cylinder surface.
The sensor has an internal thermistor for temperature compensation, and a separated amplification circuit as described in Figure 5 is used for the signal processing of each sensor.
GSK-3 To maintain a constant distance between the sensor and cylinder, the front side of the sensor sellectchem module is in contact with the cylinder surface.Figure 5.A schematic diagram of amplification circuit.3.2. Experimental set-upA schematic diagram of the experimental setup is shown in Figure 2. In the middle of the setup, the cylinder is placed in a cooling water pan on top of a turn table. A rod heater is installed at the top of the cylinder, and is connected to the adjusted selleck products power supply. The cooling water circulated from a thermostat (Daeil Engineering, Korea, Model DTC-312) is provided to give large temperature gradient on the cylinder.